How To Snake A Clogged Sink. Next, take the hook end down the drain carefully as you hold the other end with rubber gloves. Okay so ignore my stupid title, but my drain is clogged in my bathroom.
Clogged Kitchen Sink Past Trap Kitchen Sink from fluhealer.blogspot.com
How do i lift the drain thingy out so i can properly snake my bathroom sink? Place the snake down the drain slowly as you feel any blockage along the way. You should be able to feel the blockage moving out of the way.
After The Clog Has Been Cleared, Take The Drain Snake Out And Wash It With Hot Water To Clean Off Any Bacteria.
Okay so ignore my stupid title, but my drain is clogged in my bathroom. For a bathroom sink drain, you should be fine using a top snake unless it is a particularly tough clog. Use a plumber’s snake this particular tool will clean a clogged kitchen sink in seconds.
To Run The Drain Snake, Position Yourself With The Snake Close To The Opening Of The Drain Pipe.
I need to snake the drain but i can’t lift the stopper out to get all the hair out ; Slowly push the drain snake cable into the drain, turning the handle to extend the coil. You should also rinse the drain with hot water to let any residue flow through the pipes.
How To Snake A Drain Try Using Boiling Water To Fix A Clogged Sink Most Clogs In Sinks And Tubs Are Due To A Combination Of Hair, Grease, Soap Residue, And Tepid Water That Are Trapped In The Drain Trap Right Below The Drain Opening.
If you’re going in through the sink drain, you may need to remove the stopper, hair trap, or any other pieces in the way. Let it sit for about an hour, then flush it out with hot water. You should be able to feel the blockage moving out of the way.
To Release The Clog, Move The Snake Up, Down, Left And Right.
Then, stop and scoop up the clog pieces. When you hit the clog, tighten the set screw at the front of the snake. If the clog has been cleared, your sink will function as normal.
Next, Take The Hook End Down The Drain Carefully As You Hold The Other End With Rubber Gloves.
Simply mix 1/3 cup of baking soda with 1/3 cup of vinegar in a measuring cup. Secure the plumbing snake by tightening the nut assembly near the handle of the snake. From there, they remove the blockage with a snake or auger, then clean the pipe with a forceful blast of water.
